IntraBulk

Bulk Reception Unit

Overview

The IntraBulk is an above ground bulk material reception solution providing a user friendly, cost effective alternative to conventional below ground intake pits.

The reduction and consequent cost savings achieved from eliminating the need for expensive civil works has seen the IntraBulk selected across a diverse range of industries.

Operating Procedure
Receiver / Buffer Storage

The IntraBulk is capable of receiving bulk materials from a range of bulk handling vehicles including:- road tipping trucks, front end loading units and walking floor trailers.

The wide Apron-Belt design permits a very low loading height allowing the trucks to discharge direct to the entry section with only a small access ramp.

Material is discharged from the truck into the IntraBulk receiving hopper and also starts to convey further into the holding section of the unit

Once the truck has completely discharged its contents into the IntraBulk it leaves the unloading area. The IntraBulk now moves the discharged material forward into the process system or acts as a buffer store

The next truck arrives and starts the process of material discharge again

Receiver / Feeder into Process

High capacity discharge from trucks can be achieved at rates of up to 500m3/hr. By using a load regulating plough device the material can be accurately controlled in conjunction with the belt operating speed

Once the IntraBulk has been commissioned, trucks can rapidly discharge their loads with minimum vehicle turnaround

The Features

IntraBulk Product Range:

RU2000
Low Density materials
RU3000
Medium Density Materials
RU4000
High Density Materials

1. Tension Unit

2. Intake Hopper

3. Horizontal Section

4. Bend Section

5. Inclined Section

6. Drive Unit

7. Conveying Chain & Belt

8. Outlet Chute

9. Inclined Section Support

10.Hydraulic / Mechanical Drive

11. Intake Ramp & Curtain

12. Ultrasonic Vehicle Detection

13. Traffic Lights

14. Warning Beacon

15. Enclosure

16. Plough Unit

17. Head Chute Level Detector

18. Head Chute High Level Switch

19. Rotation / Speed Monitor

20. Manual Stop / Start

IntraBulk
Bulk Reception Unit

The IntraBulk is an above ground bulk material reception solution providing a user friendly, cost effective alternative to conventional below ground intake pits. The reduction and consequent cost savings achieved from eliminating the need for expensive civil works has seen the IntraBulk selected across a diverse range of industries.

The IntraBulk is capable of receiving bulk materials from a range of bulk handling vehicles including road tipping trucks, front end loading units and walking floor trailers. The wide Apron-Belt design permits a very low loading height allowing the trucks to discharge direct to the entry section with only a small access ramp.